UP FOR SALE
CLUTCH BELT
ODES 1000 FX-3, MXU 1000, Workcross, Warrior
'CV Tech' Factory, CVT, Drive Belt
33.4mm x 1085mm
Fits ODES 1000 UTV'S with newest engine (see picture below)
that has the Rear Diff and Transmission in the same Cases.
This Rubber Grommet has 2 different sizes for the same models. Please Measure your original or the O.D. of the Post Shaft.Please Study the Picture and decide which to order.It's best to add some grease not to tare the rubber hole.
Please reuse your old weights from each Slider.
If you need the Sliders with the Weights inside search same with Weights.
- Out of stock
The 0ld Flywheel of 4.1" and 4.5" Black Plug Flywheel is not in production and not available.
This Grey Plug Rotor for the Gray Plug Flywheel is all that is available.
Up for Sale is a Complete 750 Engine.
This is for the Bench Seat Model 2015-2024
(Can be installed on the 2 Bucket Seat Model 500, 550 or 700 Also)
Engine comes compete as shown with the Updated Clutch and Throttle Body Cap.
We include the New Dual Stage Air Filter and extra Oil Filter
and 2 Exhaust Head Pipe Gaskets.
These Engine are Pre-Tested for 1 Heat Cycle to Pass H.P. Rating and EPA Emissions.
These Engines ship by Fed-Ex LTL Truck and
Some Early Models did Not have Rear Calipers, Just the Center Parking Disc. That is a 3-Brake System.These Pads are good for 3-Brake and 5-Brake Systems and normally had Red Calipers. 2011-2015ish.
This Repair kit is for 1 Rear Knuckle, replaces Top and Bottom Bushings.The inner Bushing Tube is for the 10mm O.D. Bolt (other size is 12mm)Simply remove the Nut from the upper or lower Knuckle Bolt and measure the O.D. of the threads.It will be closer to 10mm or 12mm.
